1、鉆探式抽砂船等機器長期存放時，為防止液壓缸活塞桿生銹，應把工作裝置著地放置；
2.整機洗凈并干燥后存放在室內干燥的環境中；
3.如條件上所限只能在室外存放時，應把機器停放在排水良好的水泥地面上； 4.存放前加滿燃油箱，潤滑各部位，更換液壓油和機油，液壓缸活塞桿外露的金屬表面涂一薄層黃油，拆下蓄電池的負極接線端子，或?qū)⑿铍姵匦断聠为毚娣牛?
5.根據低環境溫度在冷卻水中加入適當比例的防凍液；每月啟動發動機一次并操作機器，以便潤滑各運動部件，同時給蓄電池充電；打開空調制冷運轉5-10min。
1, drilling sand pump and other equipment for a long time, in order to prevent the hydraulic cylinder piston rod rust, should put the work device to place;
2.整機洗凈并干燥后存放在室內干燥的環境中；
2 the whole machine is washed and dried and stored in a dry environment;
3.如條件上所限只能在室外存放時，應把機器停放在排水良好的水泥地面上； 4.存放前加滿燃油箱，潤滑各部位，更換液壓油和機油，液壓缸活塞桿外露的金屬表面涂一薄層黃油，拆下蓄電池的負極接線端子，或?qū)⑿铍姵匦断聠为毚娣牛?/p>
3. If conditions limited only in outdoor storage, should the machine parked in the good drainage of the cement on the ground; 4. Before storing to fill the fuel tank, lubricating parts, replacement of hydraulic oil and lubricating oil, the piston rod of the hydraulic cylinder is exposed metal surface coated with a thin layer of butter, remove the battery negative terminals, or remove battery stored separately;
5.根據低環境溫度在冷卻水中加入適當比例的防凍液；每月啟動發動機一次并操作機器，以便潤滑各運動部件，同時給蓄電池充電；打開空調制冷運轉5-10min。
5. According to the minimum ambient temperature in cooling water adding an appropriate proportion of antifreeze per month. Start the engine a and operate the machine, to lubricate the moving parts, at the same time to charge the battery; open air conditioning refrigeration operation 5-10min. |
.jpg)
